And then, she replaces the unwrapped rod with the lease stick from the upper shed. With the cord pulled taut around the rod, you will tie it with a secure double bow, followed by a knot.Ĭlaudia releases the rod attached to her back strap and pulls the newly wrapped rod down towards her waist. Once the wrapping of the cord is complete, you will manually tighten each loop, pulling all of the excess cord down the line. Claudia wraps the cord once through every interval created by the spacing of the threads. Then, you will tightly wrap the cord around the edge of the rod several times, before continuing to wrap it down the entire length of the rod. You will tie one end of the cord to the lower warp rod with a secure bow. The width created by these separations will be the ultimate width of the fabric. Now you will take a thick cotton cord and guide it through the space created by the lower warp rod, again, separating the two sheds. This next part is not precise, but try to keep the spaces and sections even, as you separate the threads into small groupings. You will now insert your lease stick in the gap at the upper warp rod, which separates the upper and lower sheds. Once sitting, Claudia takes the loops of her back strap and ties them tightly around the ends of her lower warp rod. The tension helps keep the threads in place. She places the loops around the notches of the rods and continually pulls on the loom to create tension, as she sits. At the end of the lasso, there are 2 small loops, which fit into either side of the warp rod. She then inserts the 2 warp rods – the upper and the lower – into the 2 holes created by the figure “8”.Ĭlaudia has already placed her back strap on her seat and has tied a lasso around the column, with which she will attach her warp rods. Once Claudia is finished wrapping the warp, she ties another one-loop bow and cuts the thread.Īt this point, Claudia slips her hands into the two holes of the figure “8” and removes the warp from the pegs. Note that Claudia is counting every thread and has pre-calculated the length of the final piece. This should continue in the exact same direction the entire time.Īs Claudia wraps the thread, she continually pushes the threads down the peg. The thread should cross the center each time and come around the outside of the peg. ![]() Take the thread and start winding around the pegs in a continuous figure “8”. Don't tie a knot so that you'll be able to undo it more easily later. You will start by loosely tying your thread on the left peg, with a small one-loop bow. The craftswoman in the photos and video is Sra Claudia Vega from Panchimalco, El Salvador. That’s why the traditional backstrap weaving you can try at home, after watching a few videos and reading a few instructions. ![]() All you need is a few different wooden sticks. While to learn weaving on the ordinary 4-post loom is a complicated task – because you have to get this machine and find a place for it in your home – weaving on a simple backstrap loom is much easier. ![]() These days, many people around the world are getting involved in traditional clothing crafts, retrieving the almost lost knowledge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |